This advanced 4-day course was created to give students a more
in-depth and greater understanding of hydraulics.
This course will incorporate component symbols learned in the
Basic Hands-On Hydraulic Training Seminar in developing complete
hydraulic schematics. In addition it will cover remote control of
pressure valves, bleed off orifies, using pilot valves and
introducing proportional and servo control valves. The student will
be able to perform laboratories to control multiple actuators while
maintaining fow and pressure. Other Hands-On exercises that the
student will perform are operation and setup of load sense pumps,
closed loop systems, screw-in cartridge valve, sandwich stack
valves, and proportional control valves.
Equipment the Student Will Be Using:
• Hands-on simulators for building advance labs
• Operating hydrostatic pump and motor unit
• Operating pressure compensated, load sense piston pump
• Operating servo valve
• Directional, relief and fow slip in cartridges
• Component take-apart kits.
To get the most out of this class, the student should have
previously completed our 3-day Basic Hands-On Hydraulics Training
and Troubleshooting Seminar or have equivalent knowledge.
Course Material Provided:
Rexroth's Using Industrial Hydraulics
textbook by T.C. Frankenfeld, our Volume 3 - Industrial
Fluid Power textbook, our Fluid Power
Data Booklet, a Presentation Manual and a Lab
Class size will be limited to 12 students.
Class sessions usually begin at 8:00 AM each day and will end no
later than 4:00 PM. Lunch will be provided and is included in the
tuition. There will be regular breaks with soft drinks, coffee and
bottled water. The student will receive a Certifiate of Completion
for attending all four sessions.
Upcoming Advanced Hands-On Training Seminars